Understanding Ball Joints (VIDEO)

Understanding Ball Joints (VIDEO)

Always check manufacturer specifications and specific inspection procedures to be sure you are getting the job done right.

Understanding ball joints and how to check them are an important part of every safety inspection. If the control arm transfers load directly to the suspension spring, the ball joint on that arm is a loaded ball joint because the weight of the vehicle is transferred through it to the spring. Any remaining joint is considered a follower joint, which simply serves as a pivot point.

There are many different designs of suspensions, which changes the location of the loaded or follower joints, and a typical stretch suspension only has one follower joint on each side, since the weight of the vehicle is transferred through the steering knuckle into the strut and spring. It’s important to identify the type of joint so you can also identify the proper method for inspection. When checking for ball joint wear, the manner in which you lift and support the vehicle or suspension will affect the outcome.

One example is this typical SLA suspension in which you must unload the suspension by jacking up the vehicle under the lower control arm, or the tension of the spring will prevent any play in the joints from being detectable. Another example is this SLA suspension with the coil spring above the upper arm, and you must jack the vehicle up by the frame. And on a typical strut suspension, the vehicle must also be supported by the frame. In addition to the proper support, you may check them by hand or you may have to use a pry bar, and you should always use a dial indicator to determine the amount of free play.

It’s a common misconception that any free play means a bad ball joint, but depending on the type of joint, some may be acceptable and some joints use the grease fitting position as a wear indicator. Bottom line is to always check manufacturer specifications and specific inspection procedures to be sure you are getting the job done right.

Thanks for watching The Striking Point from TechShop. I’ll see you next time.

You May Also Like

At the Intersection of Tradition and Innovation with Grace Hovis

Grace Hovis’s journey in Hovis Auto & Truck Supply blends tradition with digital innovation in the automotive aftermarket industry.

Grace Hovis's journey in the family business, Hovis Auto and Truck Supply, highlights the balance between honoring tradition and seeking innovation. Founded in 1952, Hovis Auto and Truck Supply Inc. has evolved from a small operation into a major player in the automotive parts distribution space. This evolution was fueled by a willingness to adapt and innovate, a lesson Grace learned from an early age.

The Standard® Advantage

What comes out of a repair is directly dependent upon what goes into the box. This video is sponsored by Standard®.

Tesla Model 3 TPMS Service

Resetting and programming TPMS sensors for a Tesla is a lot like any other vehicle, and the challenge is still the same: keeping the light off.

Can You Jumpstart an EV?

First things first: Find the LV battery, which could be anywhere in the vehicle.

Understanding What Antifreeze/Coolant Actually Does

Today, each manufacturer has its own formula for best results in their vehicles. This video is part of the Group Training Academy.

Other Posts

Read ShopOwner’s April Issue Online Now!

ShopOwner includes valuable business management and technical editorial content.

Monitor Water Quality When Servicing Coolant

The harder the water, the more likely the water pump is to develop a leak.

Aftermarket Division of Bosch Launches EV Training Tour

Training for up to 20 attendees per eight-hour workshop will be available over the course of 20 weeks.

ASE Education Foundation Seeking Outstanding Instructor

Nominations are being accepted for the 2024 Byrl Shoemaker/ASE Education Foundation Instructor of the Year award.